Blog, Makes

Chair makeover using Vintage Tapestries

Materials

Annie Sloan paint in Provence and Aubusson, Annie Sloan furniture wax, Old tapestries, Thread, Paper to make a pattern, Upholstery tacks, Decorative upholstery nails, chair to upholster

A chair in need of a makeover

Equipment A cotton rag, Sandpaper Paint brush, Needle-nosed pliers, Pins, Paper Cutting Scissors , Dressmaking scissors, Sewing machine, Iron and ironing board, Small pin hammer

Instructions

1. Using the needle-nosed pliers prize out any old upholstery nails and tacks. Carefully remove the fabric and pin the pieces, right side up, on the paper and draw round them and then cut out to make a pattern. Cut out the patterns.

2. Place the tapestries on the chair and arrange and re-arrange until you are happy with the composition. When you are happy, create sections of tapestry patchwork by machine stitching oblongs onto one another. Iron all the seams flat.

Arranging old tapestries on the chair

3. Pin the paper pattens onto the wrong side of the tapestry patchwork, allowing at least a 5cm (2inch) seam allowance all the way round each piece. Lay the sewn patchwork on the chair and check you are happy with it before cutting it out.

4. Paint the Provence paint onto the wooden parts of the chair and leave to dry. Paint the Aubusson over the Provence and leave to dry. Sand back parts of the second colour. To finish the paint work, rub in wax with a cotton cloth,

The finished paint result after painting with Provence and Aubusson on top then sanded back

5.  Pin each section of the tapestry onto the chair. Start attaching the pieces using the upholstery tacks. Start with the front of the chair. Begin in the middle and work outwards, stretching and pulling as you go. Apply a tack every 3cm(11/4in). Pull the fabric so it is as taut as possible before you put in the tacks. When you have reached one end, go back to the middle and start again, working in the opposite direction.

6. Repeat the process to attach the other patchwork tapestry pieces on the chair front and then the chair back. Always work from a centre point outwards, applying tacks in one direction and then the opposite direction, so that you don’t get twisting and distortion. Check that you are happy with your work and make adjustments as necessary.

Decorative upholstery nails on top of the tacks.

To finish hammer the decorative upholstery nails down the sides at the back of the chair, covering the tacks you previously hammered in.