Woven Plastic bag Wall hanging

IMG_0001

It is world environment day and so I thought it would be a good idea to post a creative way of using up old Plastic bags. I purchased a simple frame loom from a thrift shop but the same one can be found at Hobby Craft. I hung the hanging from a twig I found in the garden.

Materials

Plastic bags in a variety of colours

Cotton warp thread

Fat twig or thin branch for hanging

Equipment

Loom

Weaving shuttle

Scissors

Tape measure

 

Step 1

Cut the bag into strips  0.5cm wide. Knot the strips together so you have one long strip.1 cut strips of plastic

 

Step 2

Thread the loom by tying on the thread at one side and then going backwards and forwards between the top end and the bottom end of the frame. It is important to maintain an even tension. Tie off the thread in the same way as you tied on the thread.2.thread loom

 

Step 3

So that the weaving doesn’t fall out when you finish you will need to make a twisted header. Cut a piece of warp thread about two and a half times the width of the warp. Twist the thread round each warp thread in turn. As in the image.

3Making a twisted header

Step 4

When you get to the end of the warp return in the opposite direction push the threads down and tie off at the end.

4Return in the opposite direction

Step5

Thread the plastic onto the shuttle and then starting in the middle of the warp take the shuttle under and over until you reach one end, then go back the other way.

5thread the plastic onto the shuttle a.JPG

Step 6

As you work push down the weft to cover the warp. When you have made a stripe of one colour change to another.6push the woven pieces down to cover the warp

Step 7

To make tassels cut strips of plastic (blue)about 20cm long. Choose a middle section of the hanging and put the blue plastic behind two warp threads at the same time. Wrap one side round one thread and the other round the other , pull the threads through to the front of the hanging. Add as many of these as you like. Mine  was so bunchy that when I hung it up I gave it a bit of a trim.7constructing the tassels

Step 8/9

Weave another block of flat weaving. Repeat steps 3 and 4 to finish off.9Add another block of colour

Step 10

Pull the ends off the loom and then thread onto the branch. Cut off the warp threads from the other end of the loom and knot them one to the next one.

10Pull the ends of the yarn off the loom

Tip

As you work check that you are not creating a waist by pulling in the sides of the warp as you work.

 

Hobby Craft loom http://www.hobbycraft.co.uk/dimensions-large-weaving-loom/615930-1000?queryFromSuggest=true&userInput=loom